AUDI S3 8V CYF 310HP
ECU: SIMOS 18.2
Read/Write: CMD OBD
Tuning Results: 398hp 528Nm
CHIPTUNING AUDI S3 8V CYF 310KM in a polift version for which we present below our offer of individual tuning, Stage 1. Unlike the European version, the car is equipped with a unit that goes only to the American market and Canadian with the CYF mark available only for Golf R, TT and S3. The engine works with the perfectly known Stronic / DSG DQ250 gearbox with 6 gears.
After several hours of work spent on the dynamometer, we have refined the software for safe values of engine operation parameters. The temperature parameters on the exhaust remain within a safe range. The effect of our work is a significant increase in the dynamics of the car while maintaining safe parameters of the engine.
After measuring the series, it turned out that the CYF unit does not stick out with parameters from the well-known European CJX or DJH. The car already showed 326km in the series and torque at 433Nm (over 50nm more than declared by the manufacturer). After the STAGE 1 modification, the unit revealed its potential, nearly 400KM and 530nm, all this while maintaining safe engine operation parameters.
The times of the car on the road have been measured with the RaceLogic device.
Despite the very rich equipment of the car (glass roof, top audio set, etc.), which translates into a relatively large mass of the vehicle, the car copes well on the road.
0-100 – 3.8s (time to improve, no traction on 1st gear due to summer tires and negative temperature)
1 / 4miles 12.1s
Often customers ask us what data they receive on the dyno graphs we present, and how they should be interpreted. So how to read a dyno graph and...
In the world of chip tuning, there are many solutions to work on vehicle software. Device manufacturers provide the ability to read and write ECUs...
CHIPTUNING VW PASSAT B8 2.0 BITDI 240HP. The car should not only look good, but also good to ride. The TDI unit with the CUAA design equipped with...